PYRAMID ARCTIC SERIES PB1617X
Try turning on again. Disconnect all speaker connections and rca cables. How can this be resolved. Instant Repair Help over the Phone 6ya. Here’s a link to this great service Good luck! Pyramid arctic 4ch amp pbx goes right to protect
Make sure your fuses are good, you have a good ground, and make sure your amp turn on wire didn’t come loose when you were putting the deck back in. A speaker wire may have come lose and is shorting out against the frame or some other place. It overheats and shuts off alot. I do the sequence but when I turn it off and on again, it puts back the msm, which I must do to correct it definitively. You can’t post conmments that contain an email address. Troubleshoot to the component level to find out what is causing protect mode.
Answer questions, earn points and help others Answer questions. Hopefully you have warranty.
AMPLIFIER PYRAMID 2000WATT 4 CHANNEL;ARCTIC SERIES PB1617X
A short in the output stages as a result of overdriving is one likely suspect. I have freestanding Series 8 dishwasher.
Login to post Please use English characters only. Order on-line or call So sseries it wont give any watts to my two 12’s Related Question How do I hook up my amp its stuck on protection mode I do the sequence but when I turn it off and on again, it puts back the msm, which I must do to correct it definitively.
Please enter a valid email address. Pyramid Ns 12 12 Amp Noise Newer Post Older Post Home. If your amp doesn’t go into protection mode when the stereo is disconnected, then you have a problem with the stereo and not the amp, assuming you already checked for any possible shorts first. Double check all connections.
Pyramid G Band Car Posted on Nov 08, How can this be resolved.
Question about Pyramid PBX Car Amp 1 Answer Pyramid arctic 4ch amp pbx goes right to protect mode when turned on wires are good fuses are good to. Helpful 3 Not Helpful Comment Flag. Tell us some more!
Pyramid PB1617X Manuals
See all 9 customer reviews Pyramid G 7-Band Car Previous unit was receiving ok with coaxial connected but no antennae outside? It is mounted below my back sit and the heat is a problem in there. Posted by dgczac on Nov 08, Power supply in van was positive ground, so had to connect radio earth black to power white and radio power constant yellow and radio accessory red to harness earth black.
Posted on Jan 02, You have to guess what they do. Check both ends of all the wires.
AMPLIFIER PYRAMID WATT 4 CHANNEL;ARCTIC SERIES PBX – Apex Audio
Add Your Answer Tips for a great answer: Ask a Question Usually answered in minutes! Or check your RCA’s, Speaker wires?
Also check if it’s got a fuse in the end of the amp and see whether or not that’s blown. A speaker wire may have come lose and is shorting out against the frame or some other place. More Print this page Share this page.
I assume the capacitor you installed is somewhere on the power line, which would be for helping with noise. Your answer needs to include more details to help people. Hi there, Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two. If you don’t have problems with it then you wired your subs wrong.
As for the amp going into protect you pb16177x wired the subs down to too few ohms and the amp you have can’t handle it. Leave power, ground and remote wires intact. Find great deals on eBay for pyramid amplifier and pyramid amplifier 4 channel. Want Answer 0 Clicking this will pryamid more experts see the question and we will remind you when it gets answered. Pull out 1 rca jack at a time and try it.
I thought that the amplifier will come with a fan or something for cooling the whole system, but it doesnt.
20 Most Recent Pyramid PBX Car Amp Questions & Answers – Fixya
The max point reward for answering a seriees is By Gift Card i have this amp hooked up to four pyramid hyper pro subwoofers, 2 12s and 2 10s, and boy does this thing slam, i only had the volume on 12 and the rear view mirror was shaking like crazy! Disconnect all speaker connections and rca cables.
However, the emergency shutdown by heat works fine. It overheats and shuts off alot. If the outputs were blown the protect light should not light up being that they would need to work to cause the protect light to come arcgic. You can’t post conmments that contain an email address.
You can also try disconnecting your amp from your stereo and see what happens but leave the speakers connected, you don’t want to run the amp with out a load on it the speakers.
Or the ground wire aint in the right place. The email address entered is already associated to an account.